Visual Land Impulse Instruções de Operação descarregar pdf (Página 19)

BATTERIES

Eight AA batteries located in the rear section of the control

housing power the IMPULSE. The batteries are sealed off from

the electronics so that accidental water leakage into the battery

compartment will not damage the circuitry. To replace the

batteries, remove the battery access panel:

1. Remove the battery cover by partially

unscrewing the two, knurled thumb screws with a

coin or screwdriver. (The knurled knobs are

“captive screws” and do not have to be

completely removed from the battery cover.)

2. Remove the battery pack from the Control

Housing and disconnect the battery lead

connector. Be very careful not to put any undue

strain on the battery leads.

3. Remove the batteries from the battery packs.

Note the polarity markings inside the pack and

install fresh batteries. You may use regular carbon

zinc, alkaline or rechargeable Nicads.

tuning. Practice pinpointing. Reread the

appropriate part of this manual if you’re having

problems.

OPERATING TIPS

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sem comentários

Visual Land Impulse Instruções de Operação Página 19